Uber and its main competitor Lyft are competing aggressively to attract more drivers and in turn limit the access of their competitors in the drivers’ supply base. To control the supply side, it is important to analyze the ride-sharing platforms from drivers’ perspective. Using Uber and Lyft drivers’ online reviews, it is shown that drivers are slightly rating Uber higher than Lyft. Additionally, comparing Uber and Lyft rating trend over time, the analysis shows that they are closely competing to attract more drivers. On the aggregate level, drivers count job flexibility, work/life balance, and meeting new people as the main advantages of working in the ride-sharing platforms. On the other hand, the results show that drivers suffer from insufficient compensation of their op-erating costs, poor job security, experiencing bad riders’ behavior, and poor customer service.

Inconel 600 is a super alloy known for its properties like low thermal conductivity and work hard-ening. The work hardening property of this alloy makes it harder and harder during successive passes of the tool during machining. Therefore, machining of this type of material demands inno-vation in tool material, selection of proper combination of parameters and their levels for economical machining. Coated carbide tool inserts are most widely used for machining Inconel alloys. These inserts are coated with special materials by PVD or CVD technique to reduce flank wear, improve surface finish of machined components and increase the material removal rate (MRR). In this work carbide insert coated with nanocomposite coatings like AlTiN and TiAlSiN commercially known as Hyperlox and HSN2 were used and their performance during machining of Inconel 600 was studied. As improper selection of process parameter influences on the quality of products and productivity, it is important to identify the optimum combination of input process parameters. Most of the time the influence of the input process parameters on the output parameters like MRR, surface roughness and flank wear is studied independently. Information obtained through single objective optimization may not be sufficient because industries desire to optimize all the output parameters, simultaneously. Multi-objective optimization is the only solution to satisfy the requirements of industries and genetic algorithm based multi-objective optimization is adopted in this work in order to get the optimum combination of input process parameters to obtain maximum material removal rate, minimum surface roughness and minimum flank wear simultaneously.

In this study, the efficiency of integration between Taguchi and TOPSIS in multi-response optimi-zation of powder mixed electrical discharge machining (PMEDM) process was evaluated. The in-put parameters, such as workpiece and tool electrode material, polarity, pulse on time (ton), pulse off time (toff), Current (I) and powder concentration have been selected to optimize two responses; namely surface roughness (Ra) and surface hardness (HV). The results show that titanium powder mixed dielectric fluid improves multi-response optimization efficiency in PMEDM. In addition, machining conditions, such as tool electrode material, powder concentration, pulse on time, polarity, current density, A×G and B×G interactions play a very important role on S/N ratio of C* whereby powder concentration has the strongest influence. TOPSIS -Taguchi is a potential method for multi-response optimization in PMEDM. However, the optimal results using ANOVA analysis show that there is a necessity to have more studies in TOPSIS-Taguchi to improve the in-tegration efficiency between two methods for optimizing multiple responses in PMEDM.