This paper presents an investigation into the flexural behaviour of basalt FRP reinforced concrete beams through experimental and analytical methods. To achieve the research objectives, four concrete beams reinforced with steel and four identical concrete beams reinforced with BFRP bars were tested under four-point bending. The main parameters examined under the tests are the type of concrete (lightweight foam glass concrete and normal concrete) and the type of longitudinal reinforcement bars (BFRP and steel). Test results are presented in terms of failure modes; deformation crack pattern and the ultimate moment of resistance are presented. The experimental results are analysed and compared to predictive models proposed by ACI 440.1R, 2006 and BS EN 1992, Eurocode 2, for deformations and ultimate flexural capacities of the steel and BFRP reinforced concrete beams. The experimental results indicated that the flexural capacity decreased for the beams reinforced with BFRP bars compared to that of a corresponding beam reinforced with steel bars. Both types of beams failed in the modes predicted. The prediction models underestimated the flexural capacity of BFRP reinforced concrete beams. The increase in foam glass aggregate content was observed to reduce the cracking load by almost 10 - 40% and 25 - 50% for steel and BFRP reinforced concrete beams, respectively. The flexural capacities of BFRP reinforced beams were underestimated by using equations stipulated in ACI 440.1R and Eurocode 2 codes of practice.

Reinforcement of structural timber members with fibre reinforced polymer (FRP) rods offers merits over that of the conventional steel type. In recent times, near surface mounted (NSM) FRP reinforcement with timber has emerged as a promising alternative for reinforcing timber structures in both flexural and shear loading configurations. Previous investigations have shown that NSM FRP reinforcement technique has higher bond performance than externally bonded equivalents because it (NSM FRP technique) is able to utilise the full capacity of the FRP materials. In spite of these merits, the investigations and the use of this innovative technique are limited. In this paper, an experiment was conducted to investigate the bond characteristics and performance of NSM basalt FRP reinforcement with solid timber structures. In order to predict the performance of the reinforced beam structures, unreinforced control timber members of the same timber characteristics were tested. The results showed that the average bond capacity of the NSM FRP reinforced members was 16% higher than the corresponding unreinforced beams.