The present work deals with some machinability studies on tool wear and surface roughness, in finish hard turning of AISI D2 steel using PCBN, Mixed ceramic and coated carbide inserts. The machining experiments are conducted based on the response surface methodology (RSM). Combined effects of three cutting parameters viz., cutting speed, cutting time and tool hardness on the two performance outputs (i.e. VB and Ra), are explored employing the analysis of variance (ANOVA).The relationship(s) between input variables and the response parameters are determined using a quadratic regression model. The results show that the tool wear was influenced principally by the cutting time and in the second level by the cutting tool hardness. On the other hand, cutting time was the dominant factor affecting workpiece surface roughness followed by cutting speed. Finally, the multiple response optimizations of tool wear and surface roughness were carried out using the desirability function approach (DFA).

The current research copes with the optimization of the surface heat transfer coefficients of a square mild steel test specimen by spray impingement cooling. A laboratory scale experimental setup was developed at School of Mechanical Engineering KIIT University, Odisha, India to investigate the role of various process parameters to enhance the heat transfer from the surface of the heated steal specimen. The mild steel plates of dimension 120 mm × 120 mm, and different thicknesses of 4 mm, 6 mm and 8 mm were used in the experiment. The effect of the process parameters such as thickness of the tested plate, nozzle to plate distance, air and water pressure upon the surface heat transfer coefficient (HTC) was optimized. The optimization of the controlling parameters was carried out by using the desirability functions. The Design Expert 8 software was used to analyze the experimental results. A new correlation was developed for optimization of the surface heat transfer coefficient.

Trim cutting operation in wire electrical discharge machining (WEDM) is considered as a probable solution to improve surface characteristics and geometrical accuracy by removing very small amount of work materials from the surface obtained after a rough cutting operation. In this study, an attempt has been made to model the surface roughness and dimensional shift in trim cutting operations in WEDM process through response surface methodology (RSM). Four process parameters; namely pulse-on time (Ton), servo voltage (SV), wire depth (Wd) and Dielectric flow rate (FR) have been considered as input parameters in trim cutting operations for modelling. Desirability function has been employed to optimize multi performance characteristics. Increasing the value of Ton, Wd and FR increases the surface roughness and dimensional shift but increasing SV decreases both surface roughness and dimensional shift. Quadratic models have been proposed for both the performance characteristics. In present experimentation, thickness of recast layer was observed in the range of 6?m to 12?m for low to high value of discharge parameters.