This paper presents an experimental investigation on cutting temperature during hard turning of EN 24 steel (50 HRC) using TiN coated carbide insert under dry environment. The prediction model is developed using response surface methodology and optimization of process parameter is performed by desirability approach. A stiff rise in cutting temperature is noticed when feed and cutting speed are elevated. The effect of depth of cut on cutting temperature is not that much significant compared with cutting speed and feed as observed from main effects plot. The response surface second order model presented high correlation coefficient (R2 = 0.992) explaining 99.2 % of the variability in the cutting temperature which indicates the goodness of fit for the model to the actual data and high statistical significance of the model. The experimental and predicted values are very close to each other. The calculated error for cutting temperature lies between 1.88-3.19 % during confirmation trial. Therefore, the developed second order model correlates the relationship of the cutting temperature with the process parameters with good degree of approximation. The optimal combination for process parameter is depth of cut at 0.2mm, feed of 0.1597 mm/rev and cutting speed of 70m/min. Based on these combination, the value of cutting temperature is 302.950C whose desirability is one.

The present work deals with the cutting forces and cutting temperature produced during turning of titanium alloy Ti-6Al-4V with PVD TiN coated tungsten carbide inserts under dry environment. The 1st order mathematical models are developed using multiple regression analysis and optimized the process parameters using contour plots. The model presented high determination coefficient (R2 = 0.964 and 0.989 explaining 96.4 % and 98.9 % of the variability in the cutting force and cutting temperature, which indicates the goodness of fit for the model and high significance of the model. The developed mathematical model correlates the relationship of the cutting force and temperature with the process parameters with good degree of approximation. From the contour plots, the optimal parametric combination for lowest cutting force is v 3 (75 m/min) – f 1 (0.25 mm/rev). Similarly, the optimal parametric combination for minimum temperature is v 1 (45 m/min) – f 1 (0.25 mm/rev). Cutting speed is found to be the most significance parameter on cutting forces followed by feed. Similarly, for cutting temperature, feed is found to be the most influencing parameter followed by cutting speed.

Ti-6Al-4V Extra Low Interstitial (ELI) exhibits superior properties because of controlled interstitial element of iron and oxygen. The effects of four cutting parameters namely cutting speed, feed, depth of cut and tool nose radius on responses like cutting force, average cutting temperature and surface roughness have been investigated for turning of Ti-6Al-4V (ELI). Total 81 experiments have been performed in dry environment. Grey Relational Analysis has been used for multi-objective optimization. Analysis of Variance test has been carried out to investigate contribution of input parameters. The model was found fit with R-Square value of 88.74%. Regression and ANN models are developed for prediction and compared. From the Grey relational analysis, it is clear that optimum parameters to minimize cutting force, cutting temperature and surface roughness while turning Ti-6Al-4V (ELI), are cutting speed as 140 rpm, Nose radius 1.2mm, Feed 0.051mm/rev and depth of cut is 0.5mm. In comparison of regression model, the ANN model is found to be more accurate with average error of 3.57%.