The wear of cutting tools remains a major obstacle. The effects of wear are not only antagonistic at the lifespan and productivity, but also harmful with the surface quality. The present work deals with some machinability studies on flank wear, surface roughness, and lifespan in finish turning of AISI 304 stainless steel using multilayer Ti(C,N)/Al2O3/TiN coated carbide inserts. The machining experiments are conducted based on the response surface methodology (RSM). Combined effects of three cutting parameters, namely cutting speed, feed rate and cutting time on the two performance outputs (i.e. VB and Ra), and combined effects of two cutting parameters, namely cutting speed and feed rate on lifespan (T), are explored employing the analysis of variance (ANOVA). The relationship between the variables and the technological parameters is determined using a quadratic regression model and optimal cutting conditions for each performance level are established through desirability function approach (DFA) optimization. The results show that the flank wear is influenced principally by the cutting time and in the second level by the cutting speed. In addition, it is indicated that the cutting time is the dominant factor affecting workpiece surface roughness followed by feed rate, while lifespan is influenced by cutting speed. The optimum level of input parameters for composite desirability was found Vc1-f1-t1 for VB, Ra and Vc1-f1 for T, with a maximum percentage of error 6.38%.

The present research work investigated the machining of AISI304 austenitic stainless steel in terms of machining force evolution, power consumption, specific cutting force and surface roughness where a factorial experiment design and analysis of variance technique were used and several factors were evaluated for their effects on each level. The case of dry turning process was studied based on design of experiments in order to obtain empirical equations characterizing material machinability according to cutting conditions such as cutting speed, feed rate and depth of cut and the latter ones were put in relationship with the machining output variables (Ra, Fc, Kc and Pc) through the response surface methodology (RSM). Results revealed that feed rate was the most preponderant factor affecting surface roughness (71.04%). However, the depth of cut affects considerably cutting force and cutting power by (60.74% and 67.11%), respectively. In addition, the specific cutting force was found affected significantly by cutting speed with a contribution of 41.43%. The quadratic model of RSM associated with response optimization technique and composite desirability was used to find optimum values of machining parameters (104.54 m/min, 0.08 mm/rev and 0.295 mm).